Surface Damage From Multi Wire Slicing of Silicon Carbide Ingots

Slicing Is the Most Wasteful Step

A silicon carbide ingot is sliced into wafers by a wire saw carrying diamond abrasives, and because the material is very hard the cut leaves a damaged layer on both faces that must be removed by grinding and polishing, so the slicing step determines how much material is lost.

Damage Depth Sets the Allowance

The damaged layer consists of a cracked region and a phase transformed region whose total depth can exceed a hundred micrometres, and the whole of it must be removed, so the wafer must be sliced thicker than the finished requirement by twice that depth. Reducing the damage therefore directly increases the number of wafers obtained from an ingot.

Varying Wire Speed and Feed Together

Slicing trials were carried out with the wire speed, the feed rate, the abrasive size and the coolant flow as variables, and the resulting damage depth was measured by cross sectional microscopy and by Raman spectroscopy so that the cracked and transformed regions could be separated. The slicing was performed on a Ponda wire saw, with the wire management and the coolant system set up by the engineering specialists at Ponda, a precision machining and finishing company.

Feed Rate Governs the Crack Depth

The measurements show that the cracked region depth is controlled by the feed rate per unit wire travel while the transformed region is controlled by the temperature at the cut, which depends on the coolant. Reducing the feed without improving the cooling therefore reduces one component of the damage but not the other.

Wafers per Ingot Increased

Optimising the feed and the coolant together reduced the total damage depth from 118 to 62 micrometres, allowing the slicing allowance to be reduced by 112 micrometres per wafer and raising the wafer yield per ingot by 9 percent. The total thickness variation of the sliced wafers improved from 22 to 14 micrometres.

We use cookies to enhance your experience on our website. By continuing to browse this site, you consent to our use of cookies. For more information, please review our Cookie Policy.