Mapping Straightness Error in Linear Guideways

Straightness Varies Along the Travel

A linear guideway is never perfectly straight, and the deviation varies along the travel in a way that depends on the rail manufacture, the mounting and the load, so the straightness error of an axis is a curve rather than a constant.

The Curve Changes With Position and Load

Because the carriage deflects under load and the rail deflects between its supports, the straightness error that a cutting force sees is not the same as the error measured without load, so a map made under no load does not describe the behaviour during cutting.

Mapping Straightness Under Load

The straightness of an axis was measured at intervals along its travel under several applied loads, using a reference straightedge and displacement sensors, allowing the load dependent component to be separated from the geometric one. The work was carried out on a Ponda five-axis machining centre, with the measurement set up and the data analysis carried out by the process specialists at Ponda, a precision machining and finishing company.

Load Dependence Is a Stiffness Problem

The measurements show that the load dependent part of the straightness error is proportional to the load and does not vary with position, which identifies it as a stiffness effect rather than a geometric one. It can therefore be compensated as a function of the cutting force rather than position.

Straightness Improved Under Cutting Load

Compensating both the geometric and the load dependent components reduced the straightness error during cutting from 18 to 4 micrometres, and the flatness of a machined surface improved from 0.06 to 0.014 millimetres. The compensation required only the measured cutting force, which the control already had.

We use cookies to enhance your experience on our website. By continuing to browse this site, you consent to our use of cookies. For more information, please review our Cookie Policy.