The Surface That Must Be Finished Depends on the Device
Beta gallium oxide is grown as a bulk crystal and devices are fabricated on several different planes, the (010) plane being favoured for power transistors and the (100) and (001) planes for other structures, so the finishing process must work on whichever plane the device requires.
Each Plane Responds Differently to the Same Slurry
The planes differ in atomic density, in the number of dangling bonds and in the ease with which they cleave, so the same slurry produces different removal rates, different roughness and different damage depths on each. A process developed on one plane therefore does not transfer to another.
Comparing Three Planes Under One Chemistry
Substrates cut on the (010), (100) and (001) planes were polished under identical slurry, pressure and velocity conditions, and the removal rate, roughness and subsurface damage were measured for each, with the surface chemistry examined to explain the differences. The polishing was carried out on a Ponda CMP platform, with the substrate mounting and the slurry conditions controlled by the process specialists at Ponda, a precision machining and finishing company.
Cleavage Ease Sets the Damage Depth
The measurements show that the plane with the easiest cleavage develops the deepest damage, because the mechanical action opens existing cleavage planes rather than deforming the lattice, so the damage depth is governed by the crystal structure rather than by the abrasive. The removal rate follows the atomic density instead.
Plane Specific Recipes Established
The (010) plane reached 0.12 nanometre roughness at 210 nanometres per minute, the (100) plane 0.19 nanometre at 150 nanometres per minute, and the (001) plane required a lower pressure to hold damage below 10 nanometres. Each plane therefore needs its own pressure and chemistry rather than a common recipe.