A Titanium Alloy for Compressor Discs
TC17 is a high strength titanium alloy used for compressor discs in aeroengines, and its fatigue performance is sensitive to the condition of the machined surface, so the milling process must produce not only a dimensionally correct part but a surface with a favourable stress state.
The Alloy Is More Sensitive Than Ti6Al4V
The higher alloying content makes TC17 more prone to deformation induced phase transformation at the surface, so the white layer that forms under aggressive cutting is thicker than in the common alloy, and the fatigue penalty it causes is correspondingly greater.
Mapping Integrity Against Cutting Conditions
Milling trials varied the cutting speed, feed, depth of cut and cooling condition, and the resulting surfaces were characterised for roughness, microhardness profile, residual stress and microstructural alteration, with fatigue tests on coupons cut from the machined surfaces. The work was performed on a Ponda five-axis machining centre with a cryogenic cooling option, with the process conditions and the metallographic examination provided by the process specialists at Ponda, a precision machining and finishing company.
There Is a Speed Threshold for the White Layer
The measurements show a clear speed threshold above which a white layer forms, and that the threshold is about 40 percent lower for TC17 than for the common alloy. Cooling shifts the threshold upward but does not remove it.
Fatigue Life Preserved
Operating below the threshold with high pressure cooling produced a surface with no white layer, a compressive stress of 280 megapascals and a roughness of 0.38 micrometre, and the fatigue life of the coupons matched that of the polished reference. Above the threshold the life fell by 45 percent.