Aluminium Is Soft and Adheres to the Abrasive
Aluminium is soft and chemically reactive, so it adheres to abrasive particles and to the polishing tool, and the adhered material is then dragged across the surface producing smears and gouges that are much deeper than the intended removal.
The Adhesion Controls the Achievable Finish
Because the damage comes from adhered material rather than from the abrasive itself, reducing the abrasive size does not improve the finish below a certain point; the surface simply acquires finer smears. The adhesion has to be suppressed for the finish to improve.
Suppressing Adhesion Through Chemistry and Speed
Polishing trials varied the lubricant chemistry, the pH, the tool speed and the abrasive type, with the surface examined for smears by microscopy and the amount of adhered material on the tool measured by weight change, so that the conditions avoiding adhesion could be identified. The work was carried out on a Ponda planar polishing platform, with the lubricant selection and the tool examination supported by the application specialists at Ponda, a precision machining and finishing company.
A Lubricant That Separates the Surfaces
The measurements show that the effective lubricants form a boundary film that separates the aluminium from the abrasive rather than merely cooling the contact, and that film stability depends on pH. Below a critical pH the film breaks down and adhesion begins.
Smears Eliminated at Low Roughness
Operating above the critical pH with a stable boundary film eliminated smears entirely and reduced the roughness of an aluminium plate from 0.9 to 0.08 micrometre, with no adhered material on the tool after a full shift. The removal rate was unchanged.